This is my first post on this forum and I'll start off by asking a question. I have a Behringer MX3282a 32 channel 8 bus mixer that's been sitting brand new in the box until just now. My problem is baffling me and I'm not sure what to do anymore. I'm trying to connect the Left and right main outputs from the behringer board into the Behringer truth b2092a Active subwoofer which also feed to my studio monitors as well so I can monitor my board with my Studio monitor and sub. Whenever I plug the output of the board into the input of the subwoofer I get an instant feedback loop which goes through every channel on the behringer board, every channel is overloading and its like a pulsing low pitched hum which I heard through the subwoofer before i killed it. No matter what I do I still get this feedback and I was wondering what it could be? The board has never been used before and the monitors and sub will play from any other source other than the board, but when I plug any output from the board (xlr or 1/4 mains) it just kills everything. This has me confused, Thanks! Also note that I've tried plugging the board and subwoofer system into the same circuit on my Furman power conditioner so I doubt its any sort of line hum from that.
Behringer MX3282A and Truth B2092a Feedback
Aucun commentaire:
Enregistrer un commentaire