Hi all!
Im rethinking my studio wiring set up (for headphones mixes), my studio has two plates in the live room and one in the ISO.
Live plates have 8 balanced lines which i use in stereo pairs (Balanced L&R) and make the mix ITB.
My Idea is to use those 8 balanced lines as individual channels for each musician controls their own mix. (Ch1-2 Drums, Ch3 Bass, Ch4 GT1, etc)
I was planning to solder DB25 connector on those plates but i will need to Mult / Split the signal at least 1X6... so my question is:
-Is it OK to build a passive splitter (parallel wiring)?
Ill be using small active mixers for each musician (Phonic Am105 or similar) or each mixer would affect th others?
It would be too expensive to use transformers.
Thanks !!
Im rethinking my studio wiring set up (for headphones mixes), my studio has two plates in the live room and one in the ISO.
Live plates have 8 balanced lines which i use in stereo pairs (Balanced L&R) and make the mix ITB.
My Idea is to use those 8 balanced lines as individual channels for each musician controls their own mix. (Ch1-2 Drums, Ch3 Bass, Ch4 GT1, etc)
I was planning to solder DB25 connector on those plates but i will need to Mult / Split the signal at least 1X6... so my question is:
-Is it OK to build a passive splitter (parallel wiring)?
Ill be using small active mixers for each musician (Phonic Am105 or similar) or each mixer would affect th others?
It would be too expensive to use transformers.
Thanks !!
DB25 Dsub mult
Aucun commentaire:
Enregistrer un commentaire