Hi Folks
im hoping one of you out there can shed light on an issue i have regarding my Drawmer 1968mk2.
It functions fine on both channels when i use it on its own but as soon as i connect an EQ in the chain the bottom end on CH2 vanishes completely.
CH1 is perfect, i have two Neumann and two ANT EQ modules and CH1 works perfectly connected to all four of them while the opposite can be said of CH2.
For the record, when i bought it CH2 was not omitting any output at all. i sent it to Drawmer for a service who said they couldn't replicate the fault and it passed all their tests. I get it back and it did work for a little while tho half way through my first proper session and it behaves like this.
Im confused?!?!
im hoping one of you out there can shed light on an issue i have regarding my Drawmer 1968mk2.
It functions fine on both channels when i use it on its own but as soon as i connect an EQ in the chain the bottom end on CH2 vanishes completely.
CH1 is perfect, i have two Neumann and two ANT EQ modules and CH1 works perfectly connected to all four of them while the opposite can be said of CH2.
For the record, when i bought it CH2 was not omitting any output at all. i sent it to Drawmer for a service who said they couldn't replicate the fault and it passed all their tests. I get it back and it did work for a little while tho half way through my first proper session and it behaves like this.
Im confused?!?!
Drawmer 1968 issue
Aucun commentaire:
Enregistrer un commentaire