Aux send confusion on Mackie 8 buss

Just can't seem to wrap my head about this to get a clear picture of what's going on. Here's the scenario... V-drum module to 2 channels both panned hard opposite each other for stereo imaging. I send channel one aux send some signal to get some reverb. The reverb is sent back in stereo. Then I send channel 2 the same amount of signal from the same aux send. It too sends back the stereo reverb. Wouldn't that be redundancy that increases noise?



Should I be using a true stereo set up (only) for these situations?



Thanks

Aux send confusion on Mackie 8 buss